![]() Is no facility to set up a communications protocol so this has to beĭone from autostar suite which I must have open.įrom: richard seymour you're still not getting it.Įnvisage *does* have the capability to connect directly to the One further thing, If I open up the envisage software alone, there Thanks once more (it will be very satisfying and I hope informative for I have created an exception for port 5401.Īm I getting confused between two modes of communication? ![]() Presumably the IP address is 127.0.0.1 which I have thought is fixed for Opening envisage software either alone or from the Autostar suite andĬlicking on "Connect" produces the same error: Handbox" or within the Skymap - I can slew the etx to any point on the Subject: RE: Controlling Telescope from DSI "Envisage" softwarewįrom: Jim Beston have had another session with the connection problem.Ĭonnection through Comm 4 allows both control of the ETX via "Remote (The Lunar Planetary Imager, LPI, and Deep Sky Imager, DSI, are covered in the Helpful Information - Astrophotography area.) Please use an appropriate Subject Line on your message. If you have any comments, suggestions, questions or answers to questions posed here, e-mail them to me and I'll post them. ![]() This page is for user comments and information specific to the Meade Autostar Suite. Weasner's Meade Autostar Suite User Feedback AUTOSTAR SUITE USER FEEDBACK
0 Comments
Leave a Reply. |